Fs-drbd: Difference between revisions
From Bashlinux
Jump to navigationJump to search
Content deleted Content added
No edit summary |
Redirected page to DRBD |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
#REDIRECT [[DRBD]] |
|||
__NOTOC__ |
|||
= DRBD = |
|||
== How to setup DRBD with resource and meta-disk on different partition == |
|||
* On both servers* |
|||
* Create 2 separate partitions on each server, one for meta and one for data. Some meta-disk size approximations: |
|||
||'''Block device size'''||'''DRBD meta data'''|| |
|||
|| 1 GB || 2 MB || |
|||
|| 100 GB || 4+1 MB || |
|||
|| 500 GB || 16+2 MB || |
|||
|| 1 TB || 32+2 MB || |
|||
|| 2 TB || 64+1 MB || |
|||
|| 4 TB || 128 MB || |
|||
# If the meta-disk and resource partition are listed on fstab, then remove them from there |
|||
# Install drbd |
|||
<pre><nowiki> |
|||
# apt-get -y install drbd8-utils |
|||
</nowiki></pre> |
|||
# Edit `drbd.conf` to something similar to: |
|||
<pre><nowiki> |
|||
global { usage-count no; } |
|||
common { syncer { rate 100M; } } |
|||
resource srv { |
|||
protocol C; |
|||
startup { |
|||
wfc-timeout 15; |
|||
degr-wfc-timeout 60; |
|||
} |
|||
net { |
|||
cram-hmac-alg sha1; |
|||
shared-secret "B1ng0!"; |
|||
} |
|||
on SERVER-01p { |
|||
device /dev/drbd0; |
|||
disk /dev/md4; |
|||
address IP_SERVER-01p:7788; |
|||
meta-disk /dev/md3[0]; |
|||
} |
|||
on SERVER-01s { |
|||
device /dev/drbd0; |
|||
disk /dev/md4; |
|||
address IP_SERVER-01s:7788; |
|||
meta-disk /dev/md3[0]; |
|||
} |
|||
} |
|||
</nowiki></pre> |
|||
# Create resource and meta-disk |
|||
<pre><nowiki> |
|||
# drbdadm create-md srv |
|||
</nowiki></pre> |
|||
# Start DRBD |
|||
<pre><nowiki> |
|||
# service drbd start |
|||
</nowiki></pre> |
|||
* On primary* |
|||
When finish the previous setup on both servers |
|||
# Tell DRBD which one is the primary |
|||
<pre><nowiki> |
|||
# drbdadm -- --overwrite-data-of-peer primary all |
|||
</nowiki></pre> |
|||
This going to take a long, depending of the size of the drive. The sync can be watched at `/proc/drbd` file. |
|||
# When drbd sync is done, then, create the filesystem on drbd device |
|||
<pre><nowiki> |
|||
# mkfs.ext4 /dev/drbd0 |
|||
</nowiki></pre> |
|||
# Finally, mount drbd device on the primary server |
|||
<pre><nowiki> |
|||
# mount /dev/drbd0 /srv |
|||
</nowiki></pre> |
|||
Latest revision as of 05:30, 12 June 2015
Redirect to:
