Difference between revisions of "Centos-optimization"
From Bashlinux
Line 11: | Line 11: | ||
sysfs /sys sysfs defaults 0 0 |
sysfs /sys sysfs defaults 0 0 |
||
proc /proc proc defaults 0 0 |
proc /proc proc defaults 0 0 |
||
− | / |
+ | /customswap swap swap defaults 0 0 |
</nowiki></pre> |
</nowiki></pre> |
||
Line 57: | Line 57: | ||
hiddenmenu |
hiddenmenu |
||
password --md5 $1$/omJBwhD$phlKUXHDZI6BMLkNSfNgD/ |
password --md5 $1$/omJBwhD$phlKUXHDZI6BMLkNSfNgD/ |
||
− | title |
+ | title Bashlinux |
root (hd0,0) |
root (hd0,0) |
||
kernel /boot/vmlinuz-2.6.18-53.el5 ro root=LABEL=/ rhgb vga=792 lpj=998235 reboot=soft quiet |
kernel /boot/vmlinuz-2.6.18-53.el5 ro root=LABEL=/ rhgb vga=792 lpj=998235 reboot=soft quiet |
Revision as of 08:36, 3 February 2010
CentOS Optimizations
Disk
In order to speedup the disk management, some values are added to each `ext3` partition on the terminal. The reference site is located at [[1]]
LABEL=/ / ext3 defaults,noatime,data=writeback,commit=120 1 1 tmpfs /dev/shm tmpfs defaults 0 0 devpts /dev/pts devpts gid=5,mode=620 0 0 sysfs /sys sysfs defaults 0 0 proc /proc proc defaults 0 0 /customswap swap swap defaults 0 0
noatime
Don't write access time
data=writeback
The data order is not preserved when writes to disk. Just after set this value and before restart the terminal run the following command to avoid goes into read-only mode.
tune2fs -o +journal_data_writeback /dev/hda1
commit=120
Set the time to sync data and metadata.
System
In `/etc/sysctl.conf` set the vualue
kernel.shmmax = 63554432
to increase Maximum shared segment.
Boot
Reduce boot time passing the known values to the kernel, the site that references. Optimizations can be found at [[2]]
# grub.conf generated by anaconda # # Note that you do not have to rerun grub after making changes to this file # NOTICE: You do not have a /boot partition. This means that # all kernel and initrd paths are relative to /, eg. # root (hd0,0) # kernel /boot/vmlinuz-version ro root=/dev/hda1 # initrd /boot/initrd-version.img #boot=/dev/hda default=0 timeout=0 splashimage=(hd0,0)/boot/grub/splash.xpm.gz hiddenmenu password --md5 $1$/omJBwhD$phlKUXHDZI6BMLkNSfNgD/ title Bashlinux root (hd0,0) kernel /boot/vmlinuz-2.6.18-53.el5 ro root=LABEL=/ rhgb vga=792 lpj=998235 reboot=soft quiet initrd /boot/initrd-2.6.18-53.el5.img
lpj
Loops per jiffy can be obtained from `/var/log/messages`
reboot=soft
When reboots, the firmware will be skipped.
quiet
Doesn't log all the boot messages to the `stdout`