Difference between revisions of "Microchip PIC"
From Bashlinux
Line 2: | Line 2: | ||
= PIC = |
= PIC = |
||
+ | == Cautions == |
||
+ | === Config === |
||
⚫ | |||
⚫ | |||
⚫ | |||
− | <pre><nowiki>#!wiki caution |
||
− | '''JDM specific warnings''' |
||
+ | === Initialization === |
||
⚫ | |||
+ | # ALWAYS set the input pins and clear the output pins, excepting UART TX/RX. |
||
⚫ | |||
+ | i.e. SDO should have TRISX bit cleared, SDI should have TRISX bit set. |
||
− | </nowiki></pre> |
||
− | |||
− | |||
⚫ |
Revision as of 08:14, 14 April 2011
PIC
Cautions
Config
- NEVER disable the PIC's /MCLR (Reset) pin function
- NEVER program a PIC 'in circuit' with ANY other connections to the target board
The config options must have always `MCLRE_ON` and a 10K pull-up resistor to Vdd.
Initialization
- ALWAYS set the input pins and clear the output pins, excepting UART TX/RX.
i.e. SDO should have TRISX bit cleared, SDI should have TRISX bit set.