Microchip PIC
From Bashlinux
Cautions
Config
- NEVER disable the PIC's
/MCLR
(Reset) pin function - NEVER program a PIC "in circuit" with ANY other connections to the target board
Circuit Design
- ALWAYS set
MCLRE_ON
in the config options and haveMCLR
pin with a 10K pull-up resistor to Vdd.
Initialization
- ALWAYS set the input pins and clear the output pins, excepting UART TX/RX.
i.e. SDO should have TRISX bit cleared, SDI should have TRISX bit set.
Configuration Fuses
MPLAB 8.x
__CONFIG(1,HS&CPUDIV1) ; // Conf Reg 1: Use external crystal 4MHz __CONFIG(2,WDTDIS) ; // Conf Reg 2: Watchdog off __CONFIG(3,PBADDIS) ; // Conf Reg 3: Configure PORTB<4:0> pins as digital I/O on Reset __CONFIG(4,XINSTDIS) ; // Conf Reg 4: Extended CPU Enable Disabled
MPLAB X v2.35
#pragma config PLLDIV = 1 // No prescale (4 MHz oscillator input drives PLL directly #pragma config CPUDIV = OSC1_PLL2 // [OSC1/OSC2 Src: /1][96 MHz PLL Src: /2] #pragma config FOSC = HS // HS oscillator, HS used by USB #pragma config WDT = OFF // Watchdog off #pragma config PBADEN = OFF // Configure PORTB<4:0> pins as digital I/O on Reset